The DYNES project is currently using the Dell S4810, Dell 8024F, and Dell 6048.
Dell/Force10 S4810
The hardware configuration information for the S4810 is available [dynes:here].
- Dell S4810 switch documentation:
The S4810 environmental specifications are:
S4810 |
||||
Input Power: |
350 |
watts |
1194 |
btu/h |
Input Current: |
|
|
4.2 |
amps |
Sound Power Level: |
|
|
5.96 |
bels |
Airflow Rate: |
|
|
|
|
Weight: |
6.54 |
kg |
14.39 |
lbs |
Air Temperature Rise: |
|
|
|
|
Procedure to upgrade the S4810 firmware ** In enable mode... ** See which of A: or B: the switch currently boots from ** You'll want to load the new system in the "other" location ** The current boot location has [boot] after it show boot system stack-unit 0 ** You can specify tftp, ftp, or sftp ** Load new system into A: or B:. Best not to overwrite what you load from now. upgrade system tftp: A: ** The switch will prompt for the tftp server address and filename ** When complete, enter configure mode: configure boot system stack-unit 0 primary system: A: exit ** Now back at EXEC privilege mode write memory reload ** After the reload show version ** Check to be sure the next boot gets the correct system ** You should see [boot] after the system you want show boot system stack-unit 0
Dell PowerConnect 8024/8024F
The hardware configuration information for the 8024f is available [dynes:here].
- Dell 8024F switch documentation:
Dell 6248
The hardware configuration information for the 6048 is available [dynes:TBD].
- Dell 6248 switch documentation: