The DYNES project is currently using the Dell S4810, Dell 8024F, and Dell 6048.
Dell/Force10 S4810
- The hardware configuration information for the S4810 is available [dynes:here].
- Dell S4810 switch documentation:
The S4810 environmental specifications are:
S4810 | ||||
Input Power: | 350 | watts | 1194 | btu/h |
Input Current: |
|
| 4.2 | amps |
Sound Power Level: |
|
| 5.96 | bels |
Airflow Rate: |
|
|
|
|
Weight: | 6.54 | kg | 14.39 | lbs |
Air Temperature Rise: |
|
|
|
|
Code Block |
---|
Procedure to upgrade the S4810 firmware ** In enable mode... ** See which of A: or B: the switch currently boots from ** You'll want to load the new system in the "other" location ** The current boot location has [boot] after it show boot system stack-unit 0 ** You can specify tftp, ftp, or sftp ** Load new system into A: or B:. Best not to overwrite what you load from now. upgrade system tftp: A: ** The switch will prompt for the tftp server address and filename ** When complete, enter configure mode: configure boot system stack-unit 0 primary system: A: exit ** Now back at EXEC privilege mode write memory reload ** After the reload show version ** Check to be sure the next boot gets the correct system ** You should see [boot] after the system you want show boot system stack-unit 0 |
Dell PowerConnect 8024/8024F
- The hardware configuration information for the 8024f is available [dynes:here].
- Dell 8024F switch documentation:
Dell 6248
- The hardware configuration information for the 6048 is available [dynes:TBD].
- Dell 6248 switch documentation: